Installing the capture board – Sony DVBK-2000 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the capture
board
Notes on installing the board
• Turn off the power on your PC and peripheral
equipment before installation or removal. If you do
not, the DV capture board, PC and peripheral
equipment may be damaged.
• Do not directly touch the components on the board,
or they may be damaged by static electricity. If you
need to touch the board, touch a metal object to
discharge the electricity before you touch the board.
• Be sure that the current consumption of installed
board does not exceed the maximum supplied
current rating. The DV capture board requires a
current of 0.6 A at maximum. If you install other
boards on your PC, refer to each instruction manual
to check how much electrical current is required.
• Do not leave the board on a surface which is prone
to static electricity, for example, on the carpet. This
may damage the board.
• Do not directly touch the connectors on the board.
• The board incorporates sophisticated electronic
parts. Do not drop or damage the board.
• When removing the board from your PC, refer to
the instruction manual for your PC. If you
disconnect it by force, the DV capture board and PC
may be damaged.
• Do not moisten the DV capture board.