Sony KV-32S42 - Manual (Page 36)

^ Operating a Cable Box or Satellite Receiver
If the remote control doesn't work Cable box code numbers
Programming the remote
control
You can program the supplied remote
control to operate a cable box or satellite
receiver.
1 Press CODE SET.
2 Press SAT/CABLE (FUNCTION).
3 Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
4 Press ENTER.
For more details on operating the
cable box or satellite receiver
Refer to the operating instructions that were
supplied with the equipment.
First, try repeating the setup procedures
using the other codes listed for your
equipment.
Tips 'ii'
• If more than one code number is listed, fry
entering them one by one until you come to the
correct code for your equipment.
• If you enter a new code number, the code number
you previously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control.
In this case, use the equipment's supplied remote
control.
• Whenever you remove the batteries, the code
numbers may revert to the factory setting.
Manufacturer Code
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. 1. 201, 202, 203, 204, 205,
206, 207, 208, 218
Oak 227, 228, 229
Panasonic 219, 220, 221
Pioneer 214, 215
Scientific Atlanta 209, 210, 211
Tocom 216, 217
Zenith 212, 213
Satellite receiver code numbers
Manufacturer Code
Sony 801 (preset code for
remote control)
General Electric 802
Hitachi 805
Hughes 804
Panasonic 803
RCA/PROSCAN 802, 808
Toshiba 806, 807
30