Cypress SL811HS - Manual (Page 25)

SL811HS
Document 38-08008 Rev. *D Page 25 of 32
DC Characteristics
USB Host Transceiver Characteristics
Every V
DD
pin, including USB V
DD
, must have a decoupling
capacitor to ensure clean V
DD
(free of high frequency noise)
at the chip input point (pin) itself.
The best way to do this is to connect a ceramic capacitor
(0.1
μF, 6V) between the pin itself and a good ground. Keep
capacitor leads as short as possible. Use surface mount
capacitors with the shortest traces possible (the use of a
ground plane is strongly recommended).
This product was tested as compliant to the USB-IF specifi-
cation under the test identification number (TID) of 40000689
and is listed on the USB-IF’s integrators list.
Parameter Description Min. Typ. Max.
V
IL
Input Voltage LOW –0.3V 0.8V
V
IH
Input Voltage HIGH (5V Tolerant I/O) 2.0V 6.0V
V
OL
Output Voltage LOW (I
OL
= 4 mA) 0.4V
V
OH
Output Voltage HIGH (I
OH
= –4 mA) 2.4V
I
OH
Output Current HIGH 4 mA
I
OL
Output Current LOW 4 mA
I
LL
Input Leakage ±1
μA
C
IN
Input Capacitance 10 pF
I
CC
[13]
Supply Current (V
DD
) inc USB @FS 21 mA 25 mA
I
CCsus1
[14]
Supply Current (V
DD
) Suspend w/Clk & Pll Enb 4.2 mA 5 mA
I
CCsus2
[15] Supply Current (V
DD
) Suspend no Clk & Pll Dis 50
μA
60
μA
I
USB
Supply Current (V
DD1
) 10 mA
I
USBSUS
Transceiver Supply Current in Suspend 10
μA
Parameter Description Min. Typ. [16] Max.
V
IHYS
Differential
Input Sensitivity (Data+, Data–) 0.2V 200 mV
V
USBIH
USB Input Voltage HIGH Driven 2.0V
V
USBIL
USB Input Voltage LOW 0.8V
V
USBOH
USB Output Voltage HIGH 2.0V
V
USBOL
USB Output Voltage LOW 0.0V 0.3V
Z
USBH
[17] Output Impedance HIGH STATE 36 Ohms 42 Ohms
Z
USBL
[17] Output Impedance LOW STATE 36 Ohms 42 Ohms
I
USB
Transceiver Supply p-p Current (3.3V) 10 mA
@ FS
Notes
13. I
CC
measurement includes USB Transceiver current (I
USB
) operating at full speed.
14. I
CCsus1
measured with 12 MHz Clock Input and Internal PLL enabled. Suspend set –(USB transceiver and internal Clocking disabled).
15. I
CCsus2
measured with external Clock, PLL disabled, and Suspend set. For absolute minimum current consumption, ensure that all inputs to the device are at
static logic level.
16. All typical values are V
DD
= 3.3V and T
AMB
= 25°C.
17. Z
USBX impedance values includes an external resistor of 24 Ohms ± 1% (SL811HS revision 1.2 requires external resistor values of 33 Ohms ±1%).