Locating a track (multi-ams/ auto play/memory play, Notes, Note – Sony TC-WR565 User Manual
Page 8: Advanced playback operations
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advanced Playback Operations
Locating a Track (Multi-AMS/
Auto Play/Memory Play
(TC-WR665S only))
You can locate the following/previous tracks within a
range of 30 tracks (Multi-AMS: Automatic Music
Sensor) or the beginning of a tape quickly (Auto Play).
You can even locate a specific point anywhere on a
tape (Memory Play, TC-WR665S only).
RESET MEMORY
Notes
• The Multi-AMS function may not work correctly if:
— the blank space between tracks is less than 4 seconds
long.
— there is a passage of low frequencies or very low volume
within a track.
— the signal strength of the left and right channels are very
dif<^rent.
• The Multi-AMS function doesn't work on one deck
whenever the other deck is playing, recording, or in pause.
• Even if DIR MODE is set to CD, the deck stops when the
current side reaches the erre’. during Multi-AMS operation.
• The tape counters are reset to "0000" when you turn off the
tape deck.
Note
Check the direction indicator of the deck you use. When you
locate a track on tlie reverse side (when "<l" lights up), press
the button(s) in the parentheses.
To locate
Press
The beginning of the
next or succeeding
tracks
(Multi-AMS)
►► (or ◄◄) as many times as you
want during playback.
For example, to locate 2 tracks
ahead, press twice.
The beginning of the
current track
(Multi-AMS)
(or ►►) once during playback
The beginning of the
preceding tracks
(Multi-AMS)
(or ►►) as many times as you
want during playback.
For example, to locate 2 tracks
behind, press three times.
The beginning of a
tape (Auto Play)
MEMORY on the deck being used
repeatedly until "M" disappears in
the display. Then press (or ►►)
while holding down O (or O).
A particular point on a
tape (Memory Play,
TC-WR66fiS only)
MEMORY on the deck being used
repeatedly until "M” appears in the
displa^^ Find the point you want,
then press RESET to reset the tape
counter and to memorize the point.
To locate the memorized point and
start playback, press (or ►►)
while hc'lding down O (or O).
(Press ◄◄ or ►► to stop at "0000".)