Clarion DXZ575USB - Manual (Page 15)

Basic Operations
English
13
DXZ575USB
● Adjusting the treble
The treble gain and treble FREQ (center
frequency) can be adjusted as follows.
The adjustment can only be performed when
the DZE is set to “
DZE OFF ”.
2-1. Select “ TREBLE ”.
2-2. Press the [ ] button.
2-3. Push the [ SEEK PANEL ] leftward or
rightward and select from:
“
T GAIN ” ↔ “ T FREQ ”
3-1. Press the [ UP ] or [ DN ] button to adjust the
gain and FREQ (center frequency).
T GAIN : –6 to +6 (The factory default
setting is “ 0 ”)
T FREQ : 8KHz/12KHz (The factory default
setting is “ 12K ”)
3-2. Press the [ ] button to return to the
previous mode.
● Adjusting the sound restorer
The sound restorer enriches the playback of all
types of music files that have undergone any
level of data compression.
2-1. Select “ S RESTOR ”.
3-1. Press the [ UP ] or [ DN ] button to adjust.
Each time you press the [ UP ] or [ DN ]
button, the sound restorer changes in the
following order:
“ OFF ” ↔ “ 1 ” ↔ “ 2 ” ↔ “ 3 ”
∗
The factory default setting is “ OFF ”.
Set this adjustment in accordance with the
music source used.
OFF: For music sources compressed at
high bit rate
1: For music sources compressed for high
quality at low bit rate
2: For music sources compressed for
standard quality at low bit rate
3: For music sources compressed for low
quality at low bit rate
● Setting high pass filter
2-1. Select “ HPF ”.
3-1. Press the [ UP ] or [ DN ] button to select the
setting. Each time you press the [ UP ] or
[ DN ] button, the setting changes in the
following order:
“ THROUGH ” ↔ “ 50Hz ” ↔ “80Hz” ↔
“120Hz”
∗
The factory default setting is “THROUGH”
(through).
● Setting low pass filter
2-1. Select “S-W LPF”.
3-1. Press the [UP] or [DN] button to select the
setting.
Each time you press the [UP] or [DN]
button, the setting changes in the following
order:
“THROUGH” ↔ “50Hz” ↔ “80Hz” ↔
“120Hz”
∗
The factory default setting is “THROUGH”
(through).
● Adjusting the balance
2-1. Select “BALANCE”.
3-1. Press the [UP] button to emphasize the
sound from the right speaker, press the
[DN] button to emphasize the sound from
the left speaker.
∗ The factory default setting is “CENTER”.
(Adjustment range: L12 to R12)
● Adjusting the fader
2-1. Select “FADER”.
3-1. Press the [UP] button to emphasize the
sound from the front speaker, press the
[DN] button to emphasize the sound from
the rear speaker.
∗ The factory default setting is “CENTER”.
(Adjustment range: R12 to F12)
DXZ575USB_EN.book 13 ページ ２００６年１２月２５日 月曜日 午後１２時５７分