Sony KV-27TS29 - Manual (Page 12)

Chapter 1: Setting Up
Connecting TV Antenna/Cable
Although you can use either an indoor or outdoor antenna with the TV, an outdoor antenna will provide you with better picture
quality. You can receive cable TV by connecting a cable supplied by your local cable company.
Connecting VHF, UHF or VHF/UHF Combination Antenna*, or CATV Cable
75-ohm coaxial cable (round)
1 Check your antenna cable type and prepare the end
of the cable using the F-type connector.
Attach an F-type connector (not supplied).
300-ohm twin-lead cable (flat)
1 Check your antenna cable type and prepare the end of
the cable using the 300-ohm twin-lead cable.
Attach an antenna connector (not supplied).
b
c
d
y -I- v^-l
7 mm (1/4 inch) 10 mm (3/8 inch) F-type connector
3 mm (1/8 inch)
Loosen both
screws on the
connector with a
screwdriver.
Attach the cable
and tighten both
screws with a
screwdriver.
Plug the connector Into the VHF/UHF terminal at the
rear of the TV. Plug the connector into the VHF/UHF terminal at the
rear of the TV.
(Rear of TV)
VHF/UHF
(Rear of TV)
VHF/UHF
* Most combination antennas are equipped with a signal
splitter.
Remove the splitter and attach the appropriate connector.
For better picture quality, connect optional antenna cable so
that the 300-ohm twin-lead cable can be separated a
distance from the TV.
(Rear of TV)
VHF/UHF
12 Chapter 1: Setting Up