St€p 1 positioning the dryer, Initial steps for installing your dryer – LG TD-V12246E User Manual

Page 9

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

INITIAL STEPS FOR INSTALLING YOUR DRYER

The following instmctions will help guide you through the initial steps of setting up your dryer for use.

Please note that every section of this manual provides important information regarding the preparation and

use of your dryer, and it is important that you review this entire manual before proceeding with any
installation or use. More detailed instructions concerning electrical connections, gas connections, and
exhaust requirements are provided in other parts of this manual.

ST€P 1 Positioning the Dryer.

Choose a location with a solid floor for your dryer.
Place the dryer at least eighteen inches above the
floor for a garage installation. After placing the
dryer in the desired location, please make sure that
it has the required clearances shown below. If you
are installing your dryer in a manufactured or
mobile home, please refer to STEP 9 for additional
instructions.

* Most installations require a minimum 5>'h inches.

(14 cm) clearance behind the dryer for the exhaust
vent with elbow.

Leveling legs should be secured.

All four legs are stably placed on a solid and

even floor.

If dryer is not level, laundry may not tumble

properly and sensor will not detect accurate

humidity information.

When leveling, please be cautious not to injure

your fingers and toes.

If you install the dryer on the optional pedstal,

it is nessary to level with the pedestal leveling

legs.

Certain minimum clearances are required

above, behind, and

to

the sides of the unit, as

shown

telow. Those required minimum clearances

are set forth in the picture below. Please keep the
following instructions in mind when installing in a

closet or recessed area:

• Consider allowing additional clearance for

installation and servicing.

• Wall, door and floor molding may necessitate

additional clearances.

• An additional inch of clearance is recommended to

minimize noise transfer.

• Consider space needed for companion appliances,
• For closet installations, the picture below shows the

minimum required ventilation openings for the door,

A louvered door with comparable ventilation openings

is also acceptable.

3’

(7.6 cm)

(3ioor»ri

14" max \

(35,e<an}^

Advertising
This manual is related to the following products: