Cleaning, Service and adjustments – Craftsman 917.388731 User Manual

Page 13

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Slots

-¿tv,/Back

plate

Cover

tabs

Cover

Cartridge

MUFFLER
Inspect and replace corroded muffler as it
could create a fire hazard and/or damage.
SPARK PLUG
Change your spark plug each year to
make your engine start easier and run

better. Set spark plug gap at .030 Inch.

CLEANING
IMPORTANT;
For best performance, keep
mower housing free of built-up grass and
trash. Clean the underside of your mower

after each use.

^CAUTION: Disconnect spark plug wire
from spark plug and place wire where it
cannot come In contact with the spark

plug.

• Clean the underside of your lawn

mower by scraping to remove build-up

of grass and trash.

• Clean engine often to keep trash from

accumulating. A clogged engine runs
hotter and shortens engine life.

• Keep finished surfaces and wheels free

of all gasoline, oil,etc.

• We do not recommend using a garden

hose to clean lawn mower unless the
electrical system, muffler, air filter and
carburetor are covered to keep water

out. Water in engine can result in

shortened engine life.

SERVICE AND ADJUSTMENTS

^CAUTION; Before performing any
service or adjustments:

1. Release control bar and stop engine.

2. Make sure the blade and all moving

parts have completely stopped.

3. Disconnect spark plug wire from spark

plug and place where it cannot come

in contact with plug.

LAWN MOWER

TO ADJUST CUTTING HEIGHT

See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual,
REAR DEFLECTOR
The rear deflector, attached between the

rear wheels of your mower, is provided to
minimize the possibility that objects will

be thrown out of the rear of the mower into
the operator mowing position. If the

deflector becomes damaged, it should be
replaced.

TO ADJUST HANDLE

The handle on your lawn mower has
three (3) height positions - adjust to height
that suits you.

* Squeeze the bottom ends of lower

handle towards each other until the pin

in handle can be inserted into one of

the three height adjustment holes.

TO ASSEMBLE GRASS CATCHER

1. Pul grass catcher frame into grass bag

with rigid part of bag on the bottom.
Make sure the frame handle is outside
of the bag top.

2. Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold

them in warm water for a few minutes. If
bag gets wet, let It dry before using.
^CAUTION: Do not run your lawn mower

without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear
door removed or propped open.

Advertising