Engine engine speed, Storage, Lawn mower – Craftsman 917.388731 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

ENGINE
ENGINE SPEED

Your engine speed has been factory set.

Do not attempt to increase engine speed

or it may result in personal injury. If you

believe that the engine is running too fast

or too slow, take your lawn mower to a

Sears or other qualified service center for
repair and adjustment.

CARBURETOR
Your carburetor is not adjustable. If your
engine does not operate properly due to

suspected carburetor problems, take your

lawn mower to a Sears or other qualified
service center for repair and/or adjust­
ment.
IMPORTANT: Never tamper with the
engine governor, which Is factory set for
proper engine speed. Overspeeding the
engine above the factory high speed

setting can be dangerous. If you think the

engine-governed high speed needs
adjusting, contact a Sears or other
qualified service center, which has
proper equipment and experience to
make any necessary adjustments.

STORAGE

Immediately prepare your lawn mower for

storage at the end of the season or if the

unit will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a
period of time, clean it thoroughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.

1. Clean entire lawn mower (See

"CLEANING" in the Maintenance
section of this manual).

2. Lubricate as shown in the Mainte­

nance section of this manual.

3. Be sure that all nuts, bolts, screws,

and pins are securely fastened.

Inspect moving parts for damage,

breakage and wear. Replace if
necessary.

4. Touch up all rusted or chipped paint

surfaces: sand lightly before painting.

HANDLE
You can fold your lawn mower handle for
storage.

1. Loosen the two (2) handle knobs on

sides of the upper handle and allow
handle to fold down to the rear.

2. Squeeze the bottom ends of lower

handle toward each other until pins in
handle clear the brackets and pivot
entire handle assembly forward and
allow it to rest on mower.

• When setting up your handle from the

storage position, the lower handle will

require manually locking into the

mowing position.

IMPORTANT: When folding the handle

for storage or transportation, be sure to
fold the handle as shown or you may

damage the control cables.

Operator Presence Control Bar

Upper Handle-

/ i

Fold Fonvard
For Storage

^0

a

Fold
Backward

High
Med.
Low

Mowing

Lower'handle PosHion

Handle pin

3-position
Handle
adjustment
bracket

14

Advertising