Howto use your lawn mower engine speed control, To convert mower – Craftsman 917.388731 User Manual

Page 7

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

FORESIGHT !S BETTifi

THAN NO SIGHT

The operation of any lawn
mower can result in

foreign objects thrown into

the eyes, which can result

___ in severe eye damage.

Always wear safety glasses or eye
shields while operating your lawn mower
or performing any adjustments or repairs.
We recommend a wide vision safety

mask over spectacles or standard safety
glasses.

HOWTO USE YOUR LAWN MOWER
ENGINE SPEED CONTROL
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.

ENGINE ZONE CONTROL

^CAUTION; Federal regulations require
an engine control to be installed on this

iawn mower in order to minimize the risk

of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an

operator presence control bar which

requires the operator to be positioned
behind the lawn mower handle to start

and operate the lawn mower.

TO ADJUST CUTTING HEIGHT

Raise wheels for low cut and lower

wheels for high cut, adjust cutting height
to suit your requirements. Medium
position is best for most lawns.
• To change cutting height, squeeze

adjuster lever toward wheel. Move
wheel up or down to suit your require­
ments. Be sure all wheels are in the
same setting.

NOTE: Adjuster is properly positioned

when plate tab inserts into hole in lever.

Also, 9-posltion adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.

Lower Wheels for High Cut

Raise Wheels for Low

TO CONVERT MOWER
Your lawn mower was shipped ready to
be used as a mulcher. To convert to
bagging or discharging:

REAR BAGGING
• Lift rear door of the lawn mower and

place the grass catcher frame hooks
onto the door pivot pins.

• To convert to mulching or discharging

operation, remove grass catcher and
close rear door.

• Rear door must be closed.
• Open mulcher door and install dis­

charge deflector under guard as shown.

• Mower is now ready for discharging

operation.

• To convert to mulching or bagging

operation, discharge deflector must be
removed and mulcher door must be
closed.

SIMPLE STEPS TO REMEMBER WHEN

CONVERTING YOUR LAWN MOWER

FOR MULCHING-

1. Rear door closed.

2. Mulcher door closed.

FOR REAR BAGGING -
1. Grass catcher installed.

2. Mulcher door closed.

FOR SIDE DISCHARGING -
1. Rear door closed.

2. Side discharge deflector installed.
^CAUTION: Do not run your lawn

mower without rear door closed or
approved grass catcher in place.
Never attempt to operate the lawn mower
with the rear door removed or propped
open.

Mulcher door

Advertising