HP 38g Graphing Calculator User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To
draw a line
1. In Sketch view, press
{{DRAW}}
and move the cursor to
where you want to start the line
2. Press {{LINE}}. This turns on line-drawing.
3. Move the cursor in any direction to the end point for the
line.
4. Press
{{OK}}
to finish the line.
To draw a box 1. In Sketch view, press {{DRAW}} and move the cursor to
where you want any corner of the box to be.
2. Press
{{BOX}}.
This turns on box-drawing.
3. Move the cursor to mark the opposite corner for the box.
You can adjust the size of the box by moving the cursor.
4. Press {{OK}} to finish the box.
To draw a
1. In Sketch view, press {{DRAW}} and move the cursor to
circle
where you want the center of the circle to be.
2. Press
{{CIRCL}}.
This turns on circle-drawing.
3. Move the cursor the distance of the radius.
4. Press {{OK}} to draw the circle.
Getting Started 1-21