Craftsman 917.249392 - Manual (Page 12)

SUPPORT POST
ASSEMBLY
RETAINER
SPRING
REAR
MOUNTING
BRACKET
SUPPORT
BRACKET
PIN
FIGURE 10
Assemble the support post assembly to the rear
mounting bracket IFig 10) using support bracket
pin and retainer spring Retainer spring shown full
size below. Support past, latch pin and retainer
spring furnisheid with bagger
Install end plug {Fig. 11) on elbow support tube. End
plug furnished with bagger.
Mount the elbow retainer and the elbow shield to
the elbow support tube (Fig. 11) using: two form­
ed washers and two 5/16 locknuts (shown full size
below). NOTE: Do not tighten. Elbow retainer,
elbow shield and hardware furnished with bagger:
ELBOW
RETAINER
FORMED WASHERS
SUPPORT POST
ASSEMBLY
END PLUG
ELBOW
SUPPORT
TUBE
ELBOW SHIELD
Locate the hole in one end of the elbow. Slide this
end of the elbow through elbow retainer (Fig. 12
-
Inset). Secure elbow to elbow retainer usirig: one
clip, one sere-,., two washers and one acorn nut
NOTE: Mount clip in hole located 2 - 1/2” from edge
of elbow Hardware shown full size below. Head of
screw and flat washer mount to the inside of elbow.
Position clip with closed end of clip facing tube open­
ing as shown in Fig 12 - Inset Tighten securely.
NOTE: Tighten hardware assembled in step 7. Elbow
and hardware furnished with grass catcher
H* ®(o)
9. Flip seat forward.
FIGURE 11
LOCKNUTS
12