Installation terminal setup, Emm-e6 quick reference card – Cabletron Systems EMM-E6 Ethernet User Manual

Page 205

Advertising
background image

EMM-E6 QUICK REFERENCE CARD

EMM-E6 QUICK REFERENCE CARD

•

Slide the EMM-E6 into the first and second slots of the MMAC chassis (as
shown below).

•

Secure the module by tightening the knurled knobs at the top and bottom of
the module.

•

Power on the MMAC chassis. Monitor the state of the CPU LED.

•

The CPU LED will flash, indicating the EMM-E6 is in boot state. During this
period, which may last up to 5 minutes, the STBY LEDs will blink to indicate
the module’s boot state.

•

Fully operational EMM-E6 should display the following LED states:

-

CPU LED flashing, indicating normal operation.

-

STBY LEDs lit or unlit, depending on the results of
spanning tree operation.

-

Appropriate BRIM/EPIM LEDs lit.

-

ON LED lit for the active Channel D EPIM.

Use the following setup parameters for a VT Terminal or Terminal Emulation
package to connect to Local Management functions.

Columns:

80 Columns

Controls:

Interpret
Controls

Autowrap:

No Autowrap

Scroll:

Jump Scroll

Text Cursor:

Cursor

Cursor Style:

Underline

Mode:

VT300, 7 Bit

ID Number:

VT320 or
VT100

Cursor Keys:

Normal

Transmit:

9600

Receive:

9600

XOFF:

XOFF at 64

Bits:

8 Bits

Parity:

No Parity

Stop Bit:

1 Stop Bit

Local Echo:

No Local
Echo

Port:

DEC-423

Auto

Answerback:

No Auto
Answerback

Keys:

Typewriter
Keys

Margin Bell:

Margin Bell

Warning

Bell:

Warning Bell

EMM-E6

INSTALLATION

TERMINAL SETUP

CH1Book Page 6 Wednesday, March 20, 1996 7:48 AM

Advertising