Craftsman 1/2HP Garage Door Opener 139.53515SR - Manual (Page 13)

Installation
A
A
LOCATE WALL CONTROL (OR ANY ADDITIONAL PUSH BUTTONS) WHERE GARAGE DOOR IS VISIBLE,
AWAY FROM DOOR AND DOOR HARDWARE AND OUT OF REACH OF CHILDREN. SERIOUS PERSONAL
INJURY FROM A MOVING GARAGE DOOR MAY RESULT FROM MISUSE OF OPENER, DO NOT ALLOW
CHILDREN TO OPERATE WALL PUSH BUTTON(S) OR TRANSMITTER.
FASTEN CAUTION LABEL ON THE WALL NEAR THE WALL CONTROL AS A REMINDER OF SAFE
OPERATING PROCEDURES.
Opener
Terminal Screws
Wall Comrol
Pushbutton
PROCEDURE: There are 4 screw terminals on the back
of the Wall Control. Connect the bell wire by color; white
to white, yellow to yellow, black to black ar^ red to red.
Fasten Wall Control to an inside garage wall with 6ABxl'
sheet metal screws provided (use anchors if installing into
drywall). A convenient place is beside the service door and
OUT OF REACH OF CHILDREN.
Run the bell wire up the wall and across the ceiling to the
garage door opener. Use insulated staples.
The receiver terminals as well as the antenna are located
on the right side panel of the opener. Position antenna wire
as shown. Then connect the bell wire to the terminal
screws according to color.
OPERATION OF WALL CONTROL
WALL CONTROL PUSH BAR
Press to open or close door.
Press again to REVERSE door during the CLOSING cycle
or to STOP door during OPENING cycle.
LOCK FEATURE
Activate Lock feature only when door is closed.
The Lock feature was designed to prevent operation of the
door from portable transmitters.
The door will OPEN from the Wall Corrtrol push bar. Key
Switch and Touch Code Transmitter. The door will CLOSE
if the Wall Control push bar is pressed and held until the
door fully closes. If the push bar is released before down
travel is completed, the door will reverse.
TO ACTIVATE: Press the Lock push button. The indicator
light MUST turn ON.
TO TURN OFF: Press the Lock push button again. The
indicator light MUST turn off. Opener will return to normal
operation.
LIGHT FEATURE
TO ACTIVATE: Press the Light push button. The indicator
light MUST turn ON. Opener light will turn on (or remain
on if opener is still In 4-1/2 minute automatic cycle).
TO TURN OFF: Press the Light push button again.
Opener light will turn off.
NOTE: To turn opener light OFF during 4-1/2 minute
automatic cycle, press the Light push button twice -
to activate and then to turn off the Light Feature. The
light will turn OFF immediately.^
WIRING INSTRUCTIONS FOR ACCESSORIES
Infrared Reversing System;
To white & black opener terminals
Key Switch:
To red & white opener terminals
13