Craftsman 1/2HP Garage Door Opener 139.53515SR - Manual (Page 14)

Installation
STEP 7
Install Lights and Lenses
Make sure antenna wire is bent down before installing
lights and lenses.
Install a 75 Watt maximum tight bulb in each socket as
shown. The lights will turn on and remain lit for 4-1/2
minutes when power is connected. After 4-1/2 minutes they
will turn off. For constant light, press the Light push button
on the Waii Control.
If light bulbs burn out prematurely due to vibration,
replace with bulbs specifically packaged for “Garage
Door Openers”.
INSTALLING LENS;
NOTE: Force and limit adjustment settings are located
on opener side panels. For convenience, lenses may
be installed after Adjustment Step 3, Page 18.
Slide each lens into the guides as shown. Snap bottom
tabs into lens slots.
75 Watt Max.
Light Bulb '
Lens
Tab
STEP 8
Connect Electric Power
A
TO AVOID SERIOUS PERSONAL INJURY FROM ENTANGLEMENT, REMOVE ALL ROPES CONNECTED
TO THE GARAGE DOOR BEFORE OPERATING OPENER.
TO AVOID DAMAGE TO GARAGE DOOR AND OPENER, MAKE DOOR LOCKS INOPERATIVE BEFORE
CONNECTING ELECTRIC POWER. USE A WOOD SCREW OR NAIL TO HOLD THE LOCKS IN “OPEN”
(UNLOCKED) POSITION.
INSTALLATION & WIRING MUST BE IN COMPLIANCE WITH LOCAL ELECTRICAL AND BUILDING CODES.
OPERATION AT OTHER THAN 120V 60Hz WILL CAUSE OPENER MALFUNCTION AND DAMAGE.
Opener MUST be permanently wired or plugged into a
grounded 3-ptong receptacle wired according to local elec­
trical codes. DO NOT use a 2-wire adapter. DO NOT use
an extension cord.
PERMANENT WIRING
CONNECTION
(if required by local code.)
Ground Tab
Green Ground
Screw
RIGHT
WRONG
IF LOCAL CODES REQUIRE PERMANENT WIRING:
A
DISCONNECT POWER AT THE FUSE BOX
BEFORE PROCEEDING.
PROCEDURE: Refer to illustration. Make connection
through the 7/8' diameter hole in top of opener chassis.
1. Remove opener chassis cover by removing the cover
screws.
2. Remove attached 3-prong cord,
3. Connect the black (line) wire to black wire on terminal
block; white (neutral) wire to the white terminal wire;
the green (ground) wire to green ground screw.
CAUTION: BE SURE THE UNIT IS GROUNDED
ACCORDING TO LOCAL CODE.
IMPORTANT NOTE: TO AVOID INSTALLATION
DIFFICULTIES, DO NOT RUN OPENER NOW.
14