Craftsman 917.272247 - Manual (Page 11)

UVCnOLUni
The operation of any tractor can result in foreign objects thrown into the
J - eyes, which can result in severe eye damage. Always wear safety
_ glasses or eye shields while operating your tractor or performing any
adjustments or repairs. We recommend standard safety glasses or a
wide vision safety mask worn over spectacles.____________________
HOW TO USE YOUR TRACTOR
TO SET PARKING BRAKE
Your tractor is equipped with an operator
presence sensing switch. When engine
is running, any attempt by the operator to
leave the seat without first setting the
parking brake will shut off the engine.
1. Depress brake pedal all the way down
and hold.
2. Pull parking brake lever up and
release pressure from brake pedal.
Pedal should remain in brake posi­
tion. Make sure parking brake will
hold tractor secure.
Attachment Clutch Switch
Push-In to Pull Out To “Engage”
“Disengaged”,
'
ignition Key
Choke
Control
Throttle,
Control
“Brake”
Position
Brake Pedal
“Drive"
Position Position
Reverse
Drive
edal
Parking Brake Cruise
Disengaged” “Engaged" Control
Position Lever
STOPPING
MOWER BLADES -
• To stop mower blades, push attach­
ment clutch switch in to disengaged
position.
GROUND DRIVE -
• To stop ground drive, depress clutch/
brake pedal all the way down.
• Move motion control lever to neutral (N)
position.
IMPORTANT: The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is de­
pressed.
ENGINE -
• Move throttle control between half and
full speed (fast) position.
NOTE: Failure to move throttle control
between half and full speed (fast)
position, before stopping, may cause
engine to “backfire”.
• Turn ignition key to “STOP” position
and remove key. Always remove key
11
when leaving tractor to prevent
unauthorized use.
• Never use choke to stop engine.
IMPORTANT: Leaving the ignition switch
in any position other than "STOP" will
cause the battery to discharge and go
dead.
NOTE: Under certain conditions when
tractor is standing idle with the engine
running, hot engine exhaust gases may
cause “browning” of grass. To eliminate
this possibility, always stop engine when
stopping tractor on grass areas.
^^CAUTION: Always stop tractor
completely, as described above, before
leaving the operator’s position.
THROTTLE CONTROL
Always operate engine at full throttle.
• Operating engine at less than full
throttle reduces the battery charging
rate.
• Full throttle offers the best bagging and
mower performance.
TO USE CHOKE CONTROL
Use choke control whenever you are
starting a cold engine. Do not use to start
a warm engine.
• To engage choke control, pull knob out.
Slowly push knob in to disengage.
TO MOVE FORWARD AND BACKWARD
The direction and speed of movement is
controlled by the forward and reverse drive
pedals.
1. Start tractor and release parking brake.
2. Slowly depress fon/vard or reverse
drive pedal to begin movement.
Ground speed increases the further
down the pedal is depressed.
TO USE CRUISE CONTROL
The cruise control feature can be used for
forward travel only.
1. With forward drive pedal depressed to
desired speed, move cruise control
lever forward to “SET’ position and
hold while lifting your foot off the
pedal, then release the cruise control
lever.
To disengage the cruise control, pull the
lever backward to “OFF” position, or fully
depress the brake pedal.
TO ADJUST MOWER CUTTING HEIGHT
The position of the attachment lift lever
determines the cutting height.