Craftsman 917.272247 - Manual (Page 26)

6 .
7.
8 .
9.
First connect RED battery cable to
positive {+) battery terminal with hex
bolt and keps nut as shown. Tighten
securely.
Connect BLACK grounding cable to
negative (-) battery terminal with
remaining hex bolt and keps nut.
Tighten securely
Close terminal access doors.
Close hood.
Keps Nut
Terminal
Access
Door
Terminal
Guard
Hex Bolt
Positive (Red)
Cable
Negative
(Black) Cable
TO REPLACE HEADLIGHT LAMP
ACAUTION; When lit, the halogen lamps
get extremely hot. Hold lamp assembly by
the holder and do not touch the bulb.
1. Raise hood.
Disconnect harness from lamp
assembly.
Rotate counterclockwise and pul!
lamp assembly out of the hole in the
backside of the grill.
Insert new lamp assembly and rotate
clockwise to lock.
Reconnect harness to lamp assembly.
Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or
prevent it from starting.
• Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp automotive-type
plug-in fuse. The fuse holder is located
behind the dash.
TO REMOVE HOOD AND GRILL AS­
SEMBLY
1
.
2 .
3.
2 .
3.
4.
5.
6
.
4.
ENGINE
Maintenance, repair, or replacement of
the emission control devices and sys­
tems, which are being done at the
customers expense, may be performed
by any non-road engine repair establish­
ment or individual. Warranty repairs must
be performed by an authorized engine
manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the
factory and adjustment should not be
necessary. Check adjustment as de­
scribed below before loosening cable. If
adjustment is necessary, proceed as
follows:
1. With engine not running, move throttle
control lever to fast position.
2. Check that speed control lever is
against stop screw. If it is not, loosen
casing clamp screw and pull throttle
cable until lever is against screw.
Tighten clamp screw securely.
Idle Fuel
Adjusting
Needle
Raise hood.
Unsnap headlight wire connector.
Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of
tractor.
When replacing hood, be sure to
reconnect the headlight wire connec­
tor.
Stop
Screw
Clamp Screw
Idle Speed
Adjusting
Screw
Throttle
Control
Cable
Choke
Control
Cable
26