Craftsman 917.272247 - Manual (Page 24)

Your tractor is equipped with an adjust­
able brake system which is mounted on
the right side of the transaxle.
If tractor requires more than five (5) feet to
stop at highest speed in highest gear on
a level, dry concrete or paved surface,
then brake must be checked and ad­
justed.
TO CHECK BRAKE
1. Park tractor on a level, dry concrete or
paved surface, depress clutch/brake
pedal all the way down and engage
parking brake.
2. Disengage transmission by placing
freewheel control in ‘Iransmission
disengaged” position. Pull freewheel
control out and into the slot and
release so it is held in the disengaged
position.
The rear wheels must lock and skid when
you try to manually push the tractor
forward. If the rear wheels rotate, the
brake needs to be adjusted or the pads
need to be replaced.
TO ADJUST BRAKE
1. Depress clutch/brake pedal all the way
down and engage parking brake.
2. Measure distance between brake
operating arm and nut “A" on brake rod.
3. If distance is other than 1-3/4", loosen
jam nut and turn nut “A” until distance
becomes 1-3/4". Retighten jam nut
against nut “A”.
4. Engage transmission by placing
freewheel control in “transmission
engaged” position.
5. Road test tractor for proper stopping
distance as stated above. Readjust if
necessary. If stopping distance is still
greater than five (5) feet in highest
gear, further maintenance is neces­
sary. Replace brake pads or contact a
Sears or other qualified service
center.
With parking brake “Engaged”
Nut “A”
TO CHECK AND ADJUST BRAKE
Jam Nut
Operating
Arm
Do not touch this nut. If further brake
adjustment is necessary contact a Sears or
other qualified service center.
Park the tractor on level surface. Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom
side of left footrest.
BELT REMOVAL-
1. Remove mower (See “TO REMOVE
MOWER” in this section of manual).
NOTE: Observe entire motion drive belt
and position of all belt guides and
keepers.
2. Disconnect clutch wire harness.
3. Remove clutch locator.
4. Remove belt from stationary idler and
clutching idler.
5. Remove belt downward from engine
pulley and around electric clutch.
6. Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over
cooling fan blades.
7. Remove belt from center span keeper
and pul! belt away from tractor.
BELT INSTALLATION -
TO REPLACE MOTION DRIVE BELT
1 .
2
.
3.
4.
5.
6 .
7.
8
.
Carefully work new belt down around
transmission cooling fan and onto the
input pulley.
Slide belt into the center span keeper.
Pull belt toward front of tractor and roll
belt around electric clutch and onto
engine pulley.
Install belt through stationary idler and
clutching idler.
Reinstall clutch locator and tighten nut
securely.
Reconnect clutch harness.
Make sure belt is in all pulley grooves
and inside all belt guides and keep-
0 TS.
Install mower (See “TO INSTALL
MOWER” in this section of manuai).
Electric
Clutch
Clutching
Idler
Stationary
Idler
Center Span
Keeper
Transmissio
Input Pulley
Clutch
Locator
Clutch
Wire
Harness
24