Craftsman 113.225931 - Manual (Page 15)

4. Hold the abrasive disc with your left hand to keep it
from turning while pushing the belt in the direction
■ of the arrow. If the abrasive belt slips over the
p u l l e y s , t u r n b o t h A D J U S T I N G s c r e w s
simultaneously a small amount to apply a little more
tension to the abrasive belt.
6. Adjust the tension so that the abrasive belt does not
slip very easily when pushing it, while you are holding
the disc.
6. Tighten the locking screws,
7. Plug in the power cord. Turn the switch "ON", and
immediately "OFF", noting if the belt moved to the
right or to the left.
H it did not move to the right or left, it is
TRACKING properly.
PUSH BELT IN DIRECTION
OF ARROW
8. IF THE ABRASIVE BELT MOVES TO THE
RIGHT:
a. Loosen the LOCKING SCREW on the RIGHT.
b. Place wrench on the ADJUSTING SCREW on the
right,
c. Push abrasive belt so it is moving while pulling the
wrench toward you. This will move the abrasive
belt to the left. PUSHING the wrench will move
the belt to the right
d. The abrasive belt is tracking properly when it is
centered on the D R I V E pulley.
IMPORTANT: If you have difficulty tracking the
abrasive belt, apply more tension.
9. IF THE ABRASIVE BELT MOVES TO THE LEFT:
a. Loosen the LOCKING SCREW on the LEFT.
b. Place wrench on the ADJUSTING SCREW on the
left.
c. Push abrasive belt so it is moving while pulling the
wrench toward you. This will move the abrasive
belt to the right. PUSHING the wrench will move
the abrasive belt to the left.
d. The abrasive belt is tracking properly when it is
centered on the DRIVE pulley.
IMPORTANT: If you have difficulty tracking the
abrasive belt, apply more tension.
LEFT
BELT
MOVING
INSTALLING BELT DUST TRAP
1. Find one 10 • 32 X 9/16" Pan Head screw and a lock-
washer among the loose parts.
15