Craftsman 113.225931 - Manual (Page 23)

trouble shooting
WABWING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE TROUBLE
SHOOTING YOUR SANDER,
TROUBLE SHOOTING CHART
TROUBLE
Motor wit! not run.
PROBABLE CAUSE
1. Defective On-Off switch.
Defective switch cord.
Defective switch box receptacle,
2. Motor protector open, (only if
your motor is equipped with an
overload protector),
3 . B u r n e d o u t m o t o r .
REMEDY
1. R e p l a c e d e f e c t i v e p a r ts b e f o r e u s i n g b e l t disc
Sander a g a i n .
2 . R e s e t p r o t e c t o r a f t e r m o to r h a s c o o l e d .
3 . C o n s u l t S e a 's S e i v i c e . A n y a t t e m p t t o r e p a i r t h i s
m o t o r m a y c r e a t e a H A Z A R D u n l e s s f i r p a i r i s
d o n e b y a q u a l i f i e d s e r v i c e t e c h n i c i a r , . R e p a i r
s e r v i c e i s a v a i l a b l e a t y o u r n e a r e s t S e a r s S t o r e .
Machine slows down
when finishing. 1. V-Belt too loose.
2. Applying too much pressure to
workpiece.
3. Too much tension on abrasive
belt.
1. Increase belt tension, see Assernbly Section,
"Motor Pulley Belt Guard and Motor
Installation."
2. Ease up on pressure.
3. Adjust tension, see Assembly Section, "Installing
and Adjusting Abrasive Beit."
Abrasive Belt Slips 1. Not enou^ tension. 1. Adjust tension, see Assembly Section, "Installing
and Adjusting Abrasive Belt."
Abrasive Belt runs
off pulleys.
1. Not tracking properly ,
2. Not enou^ tension.
1, Adjust tracking, see Assembly Section, "Instaliirrg
and Adjusting Abrasive Belt."
2. Adjust tension, see Assembly Section, "installing
and Adjusting Abrasive Beit."
Wood burns while
finishing.
. . .
1. Abra&ive disc or belt is glaz^ with
sap.
1, Replace disc or belt.
23