Craftsman 917.270814 User Manual

Page 25

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Gearshift Lever

Neu№J

Lock Gate

Adjustment
Bolt

TO ADJUST STEERING WHEEL
ALIGNMENT

If steering wheel crossbars are not

horizontal (left to right) when wheels are
positioned straight fonvard, remove

steering wheel and reassemble per

instructions in the Assembly section of this

manual.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not
adjustable on your tractor. If damage has
occurred to affect the front wheel toe-in or
camber, contact your nearest authorized

service center/department.
TO REMOVE WHEEL FOR REPAIRS
• Block up axle securely.
• Remove axle cover, retaining ring and

washers to allow wheel removal (rear
wheel contains a square key - Do not
lose).

• Repair tire and reassemble.
• On rear wheels only: align grooves in

rear wheel hub and axle. Insert square
key.

• Replace washers and snap retaining

ring securely in axle groove.

• Replace axle cover.

NOTE: To seal tire punctures and prevent

flat tires due to slow leaks, tire sealant
may be purchased from your local parts
dealer. Tire sealant also prevents tire dry
rot and corrosion.

Washers

Retaining
Ring

TO START ENGINE WITH A WEAK

BATTERY

i^CAUTION: Lead-acid batteries
generate explosive gases. Keep sparks,

flame and smoking materials away from
battenes. Always wear eye protection
when around batteries.
If your battery is too weak to start the

engine, it should be recharged. (See

"BATTERY" in the MAINTANCE section of

this manual).
If jumper cables” are used for emergency

starting, follow this procedure:
IMPORTANT: Your tractor Is equipped
with a 12 volt negative grounded system.

The other vehicle must also be a 12 volt

negative grounded system. Do not use

your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -
• Connect each end of the RED cable to

the POSITIVE (+) terminal of each
battery, taking care not to short against

chassis.

• Connect one end of the BLACK cable to

the NEGATIVE (-) terminal of fully
charged battery.

• Connect the other end of the BLACK

cable to good CHASSIS GROUND,
away from fuel tank and battery.

TO REMOVE CABLES, REVERSE
ORDER -

Axle Cover

Square Key
(Rear Wheel Only)

25

Advertising