Craftsman 247.37683 - Manual (Page 11)

ASSEMBLY
3. The rope guide is attached to the right side of the upper handle.
See Figure 3. Loosen the wing nut which secures the rope guide.
a. Hold blade control against upper handle.
b. Pull starter rope out of the engine. Release blade control.
c. Slip starter rope Into rope guide.
d. Tighten wing nut.
4. Insert post on cable tie into hole provided on the lower handle.
Pull cable tie tight and trim excess. See Figure 4.
Attaching the Grass Catcher
1. Follow steps below to assemble the grass catcher. Make certain
bag is turned right side out before assembling (warning label will
be on the outside).
a. Place bag over frame so that Its black plastic side Is at the
bottom.
b. Slip plastic channel of grass bag over hooks on the frame.
See Figure 5. All the plastic channels except center top of
bag attach from outside of bag.
c. Attach center top of bag from Inside of bag.
2. Follow the steps below to attach the grass catcher:
a. Lift rear discharge door. See Figure 6.
b. Place grass catcher on the pivot rod. Let go of discharge
door so that It rests on the grass catcher.
r
A
warning
Never operate mower unless the hooks on the grass catcher are
firmly seated on the pivot rod and the rear discharge door rests firmly
against top of the grass catcher.
A
Figure 5
Figure 3
J
Figure 6
11