Side discharge chute, Adjustments cutting height, Assembly – Craftsman 247.37683 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Side Discharge Chute
Your mower is shipped as a mulcher. To convert to side discharge,
make sure grass catcher is off of the unit and rear discharge door is
closed.
1.
On the side of the mower, lift the mulching plug. See Figure 7.
2.
Slide two hooks of side discharge chute under hinge pin on
mulching plug assembly. Lower the mulching plug.
NOTE: Do not remove side mulching plug at any time, even when you
are not mulching.
ADJUSTMENTS
Cutting Height
Each wheel has a height adjustment lever to change the cutting height
of the mower. Refer to Figure 8.
1.
Depress height adjustment lever towards wheel.
2.
Slide lever to desired position for a change in cutting height
3.
Release lever towards deck.
IMPORTANT: All wheels must be placed in the same relative position.
For rough or uneven lawns, move the height adjustment lever to a
higher position. This will stop scalping of grass.
Figure 7
12