Nikon LS-10 Installation Guide for Windows User Manual
Nikon
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Table of contents
Document Outline
- Nikon
- TRANTOR-New Horizons in SCSI Design SOFTWARE LICENSE AGREEMENT
- Introduction
- Setting Up Coolscan
- The Front Panel
- The Rear Panel - LS-10E
- The Rear Panel - LS-10
- Orientation and Placement of the LS-10E
- Transporting Coolscan
- Connecting AC Power to the LS-10E
- Safety Precautions When Connecting AC Power to the LS-10E
- AC Power Safety Precautions - LS-10E
- General Safety Precautions
- Installation Precautions
- The SCSI Interface
- System Requirements for SCSI Installation
- Setting the SCSI ID
- Terminating the SCSI Chain
- SCSI Cables
- If you are installing an LS-10, please proceed to the section “SCSI Cables Used With the LS-10.”
- SCSI cables should never be connected or disconnected while the SCSI device or the computer is powered on. Such action can damage the SCSI controller card.
- Please proceed to the section The PC’s External SCSI Connector.
- The PC's External SCSI Connector
- The PC's Internal SCSI Connector
- The SCSI Chain
- The SCSI Controller Card
- Installing the SCSI Controller Card Into the Computer
- Setting Up the SCSI Chain - LS-lOE
- Setting Up the SCSI Chain - IS-10
- About the SCSI Interface
- Mounting the IS* 10
- Software Installation
- Nikon Scanner Plug-in Software
- Coolscan Control Software
- Eject.EXE Software
- Nikon Installer Software
- System Requirements
- Running the Nikon Installer
- Installing Third-Party Applications
- Troubleshooting