Nikon LS-10 Installation Guide for Windows User Manual
Page 53
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Mounting the LS-10
Chapter 4
Once the scanner is pushed into the computer, reposition or reinsert the lock tabs
dealt with in Step 6, Procedure 4,1. The tabs should slide in front of the scanner guide
rails thereby locking the scanner in place.
Step 7. Repl acc the computer’s cover.
Replace the computer’s cover making sure not to cut, pinch or bend any internal
cables.
Step 8. Reconnect the monitor.
Step 9. Reconnect the computer’s AC power cord.
Step 10. Start the PC.
Start up the PC in the usual way. Your disk drive should boot within a few sec
onds. If your PC does not start up as it normally does, or if Coolscan’s
power/busy/error LED indicator is not lit or continuously blinking, refer to the
“Troubleshooting” chapter in this manual.
Page 46
Nikon
Coolscan Installation Guide for Windows