Canon EOS 7 - Manual (Page 72)

I Wireless Remote Control
Remote Controller RC-1 (sold separately) enables wireless remote control
operation in all the picture-taking modes.
Turn the film advance mode lever
to <Ci)l>.
► The < I > icon appears on the LCD panel.
Take the picture via remote control.
• Point the Remote Controller RC-1's signal emitter
toward the camera’s remote control sensor and
press the Send button. Wireless remote control
works within 5 meters from the camera.
• Remote shutter release is indicated as follows:
2-sec. delay: The red-eye reduction lamp lights
for 2 sec., then the picture is taken.
Immediate shutter release: When the picture is
taken, the red-eye reduction lamp flashes.
W Certain types of fluorescent lights might cause the remote control operation to work
improperly. Place the camera away from any fluorescent lights as much as possible.
0 If you set the film advance mode lever to <Ci)I > and do nothing for four minutes, the
wireless remote control mode will be canceled automatically to save battery power.
To set It again, press the shutter button halfway. The < | > icon displayed on the
LCD panel indicates that the wireless remote control mode can be used.
Using the Remote Switch
The Remote Switch RS-60E3 (sold separately) can be used in all the
picture-taking modes.
Connect the Remote Switch’s plug to
the camera’s remote control terminal.
Press the release button to take the
picture.