LG LP6010ER - Manual (Page 6)

Operating
Instructions
The remote control and control panel will look like those represented in the following pictures.
\____ /
Remote Control Operations
D POWER
• To turn the air conditioner ON, push this button.
To turn the air conditioner OFF, push the button
again.
• This button takes priority over any other button.
• When you first turn it on, the unit is in cooi mode,
high fan speed, temperature setting at 72'F.
^ TEMPERATURE SETTING
• Use this button to automaticaily controi the
temperature of the room.
The temperature can be set within a range of
60°F to 86°F by increments of 1 °F.
^ MODE
- Every time you push this button, it wiii cycie
through the foliowing modes: COOL, ENERGY
SAVER, FAN and DRY.
Dry mode is used to remove humidity from the
room without add^ional cooling.
Once the set temperature is reached,the
compressor and circulation fan turns off.
Fan speed is pre-set and cannot be adjusted.
-ENERGYSAVER
• The fan stops when the compressor stops
cooling. Approximately every 3 minutes the fan
will turn on and the unit will check the room air to
determine if cooling Is needed.
FAN SPEED
• Every time you push this button. It advances the
setting as follows: {High(F3) ->■ Low(FI) -►
Med(F2) ->■ High(F3)}
5) TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you
sleep.
• With unit mnning, use Timer to set number of
hours until shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 2°F after 30 min,
and 2°F after another 30 min.
• Every time you push Timer button, it advances
the Timer setting as follows: 1 Hour -► 2 Hours -►
etc. 12 Hours maximum.
-START TIME
• With unit not running, use timer to set number of
hours before unit starts.
• Every time you push Timer button, it advances
the Timer setting as follows: 1 Hour -► 2 Hours -►
etc. 12 Hours maximum.
6) REMOTE CONTROL SENSOR
When power is restored after an electrical power failure, the unit will begin to run at Its last setting.