Maintenance, Care, Cleaning the water inlet filters – LG WT5070CW User Manual
Page 28: O note, A warning, Care in cold climates, 7 press q to rinse + spin, Warning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
28
MAINTENANCE
MAINTENANCE
Care
Cleaning the Water Inlet Filters
If the washer detects that water is not entering the
dispenser, an error message will show on the display. If
you live in an area with hard water, this may be caused by
clogged inlet filters.
O NOTE----------------------------------
• Use extreme care when removing and cleaning the
filters. If the filters cannot be cleaned or are damaged,
do NOT operate the washer without the inlet filters,
Contact LG Customer Service or a qualified LG servicer.
1 Turn off both water taps completely. Unscrew the hot and
cold water lines from the back of the washer.
2 Carefully remove the filters from the water inlets, and
soak them in white vinegar or a lime scale remover. Rinse
thoroughly before reinstalling. Press the filters back into
place and reattach the water lines. Do NOT operate the
washer without the inlet filters.
A
WARNING
Unplug the power cord and turn off the faucets before
cleaning. Failure to do so may cause electric shock.
Do not use the washing machine without the inlet
filters. If you use the washing machine without the
inlet filters it will cause leaks and malfunction.
If you use the washing machine in an area with hard
water, the inlet filter may clog due to lime buildup.
Contact your nearest LG customer service center if the
inlet filter is not clean or is missing.
O NOTE
/ 'c message will blink on the display when the water
pressure is weak or an inlet filter is clogged with dirt.
Clean the inlet filter.
Care in cold climates
When the Water Line is frozen
1 Turn off the faucets connected with the water lines.
2 Pour hot water on the frozen faucets to thaw the water
lines and pull them out.
3 Immerse the water lines in hot water to thaw them.
4 Connect the water lines with the water inlets of the
washing machine and faucets.
- See page 14, Connecting the water lines for details.
5 Turn on the faucets.
6 Press
7
Press Q
to RINSE + SPIN.
8 Press
tTMRlMUM
- Verify the water fills properly.
When the Drain Line is Frozen
1 Pour hot water in the washer tub and close the lid.
- Leave it for 10 minutes.
2 Press after 10 minutes.
3 Press Q to
SPIN ONLY.
4 Press
- Check if the water drains.