Achronix Speedster22i HD1000 Development Kit User Guide - Manual (Page 62)

62 UG034, July 1, 2014
Appendix B
– LEDs, Buttons, Jumpers, and
Switches
The following tables list the various LEDs, buttons, jumpers, and switches on the board. You
can use these for configuration, status indication, or reset.
LEDs
Table 26: LEDs and their Functions
LED Function
Connection
Through Pin Signal
D2 Configuration status indicator U33 M16 CONFIG_STATUS
D3 Configuration done indicator CONFIG_DONE
D5 User defined AE46 BYTEIO9_DQ0_P
D6 User defined AG46 BYTEIO9_DQ1_N
D7 User defined AJ47 BYTEIO9_DQ2_P
D8 User defined AF46 BYTEIO9_DQ3_N
D9 User defined AF47 BYTEIO9_DQ4_P
D10 User defined AC46 BYTEIO9_DQ5_N
D11 User defined AJ46 BYTEIO9_DQ6_P
D12 User defined AE47 BYTEIO9_DQ7_N
DS1 U35 50 T_LED
D1 12V power indicator -- V12P0_ATX
Note: D2, D3, D7, D8, D5 – D12, and DS1 are connected to V3P3.
Buttons
Table 27: Push Buttons and their Functions
Button Function
Connection
Through Pin Comment
S1 FPGA reset* U33-43 2
User Programmable FPGA
Fabric Reset
S2 Microcontroller reset U93 2 MCU Reset Circuitry
S4 HD1000 configuration reset U97 2 FPGA Reset Circuitry
S3 Reset U91 2 Drives ON_OFF_MCU
* Usage of FPGA reset push-button requires a reset signal in the design to be routed to the IO
corresponding to the push button, which is pad2_clk_bank_sw = P17.