Acolyte DMX - Manual (Page 3)

All artwork and images copyright Acolyte Industries Inc.
Use or reprinting prohibited unless explicitly approved by Acolyte Industries.
N O T E A B O U T C O N N E C T I O N S
PA G E 2
Terminal block
input
L AYO U T A N D F E AT U R E S C O N T I N U E D
SIDE VIEW BACK VIEW
All connections (DMX, power, ports...) are made with the rear connectors.
The 9V DC power supply must be connected to the 2 Power pins, and the
1st DMX universe to the 3 DMX pins of the main 9-pin connector block (see
the picture below). This interface has 4 ports (1 to 4) to trigger 4 different
scenes. To use the input ports, you must create a connection between the
Ground pin and the ports (see the picture to the right).
The interface can be powered either with the external power supply or
through USB. You must move the “Power” button (next to the USB port) to
switch from USB to EXT.
It is very important to NEVER move the “USB TO EXT” switch while this
controller is connected to the computer.