AVer M30(310AF) user manual - Manual (Page 25)

ENGLISH
22
Start Code
Type
Code
Data
Length
Data
Code
Checksum
KEY_MENU FF 70 1 E 7F
KEY_AUTOFOCUS FF 70 1 F 7E
KEY_AUTOIMAGE FF 70 1 10 61
KEY_ZOOM_1X FF 70 1 11 60
KEY_UP FF 70 1 12 63
KEY_LEFT FF 70 1 13 62
KEY_ENTER FF 70 1 14 65
KEY_RIGHT FF 70 1 15 64
KEY_DOWN FF 70 1 16 67
KEY_ZOOM_IN FF 70 1 17 66
KEY_BRT_UP FF 70 1 18 69
KEY_DEL FF 70 1 45 34
KEY_CAM/PC FF 70 1 4A 3B
KEY_ZOOM_OUT FF 70 1 4B 3A
KEY_BRT_DOWN FF 70 1 4C 3D
T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g
This section provides many useful tips on how to solve common problems while using the
AVERVISION M30.
There is no picture on the presentation screen.
1. Check all the connectors again as shown in this manual.
2. Check the on/off switch of the display output device.
3. Verify the setting of the display output device.
4. If you are presenting from a notebook or computer through the display output device, check the
cable connection from computer RGB (VGA) output to RGB input of AVERVISION M30 and make
sure AVERVISION M30 is in PC Mode.
I have set up the AVERVISION M30 and checked all the connections as specified in
the manual but I cannot get a picture on the preferred presentation screen.
1. Once the power is connected, the LED light turns RED in standby mode. Simply switch the
AVerVision M30 “ON" by pressing the on/off switch until the LED light is blinking and turns
GREEN.
2. The default camera display resolution setting is on 1024x768. If your output device does not
support this resolution; no image can be projected. Simply press the MENU and RIGHT or LEFT
button to the increase or decrease the resolution setting.
3. If your display output device is TV or any analog device, make sure the TV/RGB display switch is
set to TV.
The picture on the presentation screen is distorted or the image is blurry.