AVer SF1031W - Manual (Page 15)

7
Chapter 2 Installing the Camera
The camera is intended for indoor use. Therefore, the power adapter and power source should be protected
from water and moisture, excessive heat, direct sunlight and cold. Please make sure the power adapter and
cord and Ethernet cable are safely arranged so they do not create a tripping hazard and will not be disturbed
by people or objects moving past.
The camera can be attached to the stand that is included in the package. The camera stand can be mounted
on a flat surface through the three screw holes on the base of the stand.
Please refer the following description to install the camera.
2.1 Attach Camera to the Stand
The IP camera comes with a camera stand, which has a swivel prop stand that can be attached to the
camera’s screw hole on the top/bottom.
1.
Screw tight the swivel prop stand and screw the black nut on the swivel prop stand.
2. And then, attach the camera on the stand.
3. Lose the wheel can adjust the camera to the wanted position. Remember to tight the swivel prop stand
after adjusting.
4. To mount the camera, using the screws to secure the camera stand on the wall.
2.2 Connect Ethernet Cable
Plug-in the Ethernet cable into the Ethernet port that is located on the rear panel of the camera. Both wired
and wireless IP camera can be installed Ethernet cable.
SF1301 SF1301W