B&M 45163 PRECISION SPORT SHIFTER - 03 - 05 NISSAN 350Z - Manual (Page 6)

STEP 18. Reinstall soft rubber boot.
STEP 19. Adjust shifter plate so that reverse pin rides on stock
stock plate while going into 6th gear. Shifter should need
to be pushed down to engage reverse.
Evenly torque bolts to 10 ft-lbs (13.6Nm).
Test movement of shifter into all gears. DO NOT operate
vehicle until all gears can be fully engaged smoothly.
NOTE: This B&M Shifter has been designed to provide an
audible click(noise) when the shifter pops out from the
reverse-down position. This should signal that reverse has
been "locked-out" until the shifter is once again depressed.
TOOL: Torque Wrench, Extension, & Hex Drive (5 mm)
STEP 17. Reinstall shift linkage bolt.
TOOLS: Socket(12 mm) and Drive
STEP 16. Install stock spring and shifter using stock plate and M6
bolts, washers, then serrated washers D . Make sure that
reverse pin is turned towards passenger side of vehicle.
TOOLS: Socket Drive, Extension, and Hex Drive(5 mm)
NOTE: DO NOT TIGHTEN BOLTS FULLY AT THIS
POINT. ENSURE SERRATED WASHERS ARE COM-
PRESSED BETWEEN FLAT WASHER AND STOCK
PLATE.
D