B&M 77101 STARTER, FORD, 3/8 DEPTH FLYWHEEL, 289, 302, 351W, 164 T MANUAL - Manual

Instructions
B&M StarTek Starter
(see www.bmracing.com for the latest vehicle fitment applications and model years)
Part Number 77100 (3/4” Depth) & 77101 (3/8” Depth)
Ford 289, 302, & 351W
© 2013 by B&M Racing and Performance Products
1 9500886-02
Proper installation of your StarTek
Starter is essential for trouble free
operation. Correct alignment and
spacing is required. Please read all
instructions before installing your
new high performance starter.
INTRODUCTION
This starter can be installed in about
an hour by carefully following the
instructions. It is suggested that the
vehicle be allowed to cool off for a
few hours to avoid burns from hot
parts, especially any exhaust parts
which might be near the starter. The
vehicle should be off the ground for
ease of installation - jack stands,
wheel ramps or a hoist will work
fine. MAKE SURE VEHICLE IS
FIRMLY SUPPORTED - DO NOT
WORK UNDER A VEHICLE IF IT IS
SUPPORTED BY ONLY A JACK!
Try to raise the vehicle 1-2 feet so
you will have plenty of room to work.
APPLICATION NOTES
When selecting a starter for your
particular Ford, year, model, and
drivetrain
specifications can
sometimes be miss-leading.
B&M offers two starters of differing
pinion depth for particular Ford 289,
302, and 351W applications. Part
number 77100 is for 3/4” depth ring
gears, and part number 77101 is
for 3/8” depth ring gears. Please
see
Figure’s 1 and 2 for
clarification, along with Table 1.
Figure 1: Application Side View