B&M 80706 PRO STICK SHIFTER - Manual (Page 8)

8
MOUNTING BRACKET AND ALUMINUM HOUSING
If the quick release mounting bracket is being used, it is
screwed to the floor with four mounting screws. One spacer
washer is required between the mounting bracket and the
shifter in the location shown in Figure #11. The shifter is held
onto the bracket with the two quick release pins.
The aluminum housing can be used with or without the mount-
ing bracket. If it is used with the mounting bracket, no spacers
are required. If it is used without the mounting bracket, four
spacer washers are required between the shifter and the cover
as shown in Figure #12. The two quick release pins are used
to hold the cover to the shifter or the shifter and mounting
bracket. A sheet of shift pattern decals is included with the
cover. Select the one that fits your shift pattern and press the
decal on the top of the housing to line up with the stick.
THREE SPEED FORWARD PATTERN (SEE FIGURE #13)
1. First Gear: (Starting with the shifter in Park) Pull the trigger
lightly until it stops, then pull the stick all the way back releas-
ing the trigger at mid travel.
2. Second Gear: Push the stick forward to stop.
3. Third Gear: Pull and hold the trigger firmly, then push the
stick forward to stop. Release the trigger and remove the
pressure from the stick allowing the spring loaded selector
pin to raise to the top of the gate opening.
4. Neutral: Push the stick forward to stop.
5. Reverse: Push the Reverse Lockout lever forward, then
push the stick forward to stop.
6. Park: Pull and hold the trigger lightly until it stops, then
while holding pressure on the trigger push the stick forward
until it stops.
2 Spd Gate 4 Spd Gate
Figure #15 Figure #16
THREE SPEED REVERSE PATTERN (SEE FIGURE #14)
1. First Gear: (Starting with the shifter in Park) Pull the trigger
lightly until it stops, then while holding the pressure on the
trigger pull the stick rearward slowly until the stick stops at
the “1” position.
2. Second Gear: Pull the stick rearward against the stop.
3. Third Gear: Pull the trigger lightly until it stops, then while
holding pressure on the trigger pull the stick rearward until it
stops.
4. Neutral: From Third, Second, or First. Pull the trigger lightly
until it stops, then while holding pressure on the trigger push
the stick forward until it stops.
5. Reverse: Push the Reverse Lockout lever forward, then
push the stick forward until it stops.
6. Park: Pull the trigger lightly until it stops, then while hold-
ing pressure on the trigger push the stick forward until it
stops.
TWO SPEED FORWARD PATTERN (SEE FIGURE #15)
1. Low: (Starting with the shifter in Park) Pull the trigger
lightly until it stops, then while holding pressure on the trig-
ger pull the stick all the way back releasing the trigger at mid
travel.
2. Drive: Push the stick forward until it stops.
3. Neutral: Pull the trigger firmly until it stops, then push the
stick forward until it stops. Release the trigger.
4. Reverse: Push the Reverse Lockout lever forward, then
push the stick forward until it stops.
5. Park: Pull the trigger lightly until it stops, then while hold-
ing pressure on the trigger push the stick forward until it
stops.