B&M 81011 MANUAL STREET ROD SHIFTER, 15 TALL STICK - Manual (Page 4)

STEP 5. Attach the Base Bracket onto the Mounting Bracket
using the supplied 5/16-24x1/2" screws (4) at the most
optimal location (note: the Base Bracket can be in
stalled fully forward or rearward, but may require addi-
tional support to prevent unwanted shifter movement, if
the shifter is mounted at these extreme locations).
STEP 8. Attach and adjust the upper stick portion of the Shifter to the desired angle.
NOTE: The stick should be attached with the supplied 5/16-18x1" screws (2),
5/16" lockwasher (2), and 5/16" flat washers (2).
STEP 6. Attach the Shifter in the most suitable location on the
Base Bracket using the supplied 5/16-24x1/2" screws (4),
5/16" lockwashers (4), & 5/16" jam nuts (4). If the Shifter
happens to be located on top of the Mounting Bracket,
then remove the interfering screws and then reinstall them
on top of the shifter side plates but do not use the wash-
ers or nuts.
STEP 7. Install the supplied 5/16-24x5/8" set screws (2) into
the tesion holes of the Base Bracket and tighten. This
will help to anchor the shifter and associated bracketry
preventing any unwanted flex and shifter movement.