B&M 81011 MANUAL STREET ROD SHIFTER, 15 TALL STICK - Manual (Page 6)

STEP 13. Install the supplied 1/4-28" jam nuts (2) and rod ends
(2) to each end of the threaded rod.
STEP 14. Attach the threaded rod and rod ends to the Selector
Lever and Transmission Lever using the supplied 1/4-
20x3/4" screws (2), 1/4" lockwashers (2), and 1/4-20" jam
nuts (2). NOTE: as the shifter assembly moves further
forward on the Base Bracket the shifter Selector Lever
may need to be moved to an earlier (higher) position than
4:30, in order not to over-center the transmission.
STEP 15. Check the adjustment of the shifter by placing it in the
"NEUTRAL" position. The rod ends should be adjusted to
where they slide easily onto the lever mounting screws.
Also ensure that each position on the shifter and trans-
mission coincide and function properly and that the
neutral/park safety switch fully actuates in "NEUTRAL"
and "PARK". Make sure to tighten the jam nuts on the
threaded rod against the rod ends after the final adjust-
ments.
STEP 16. Using the supplied terminals, wire the neutral safety
switch, making certain that the vehicle can only be started
in the "neutral" or "park" position. Adjustments can be
made by slightly loosening the screws on the switch and
sliding it into position.
CAUTION: DO NOT fully remove the screws as it will be
very difficult to replace them.