B&M 81025 CONSOLE QUICKSILVER SHIFTER FOR 1968-1969 CAMARO(AUTOMATIC TH-350 & 400) - Manual (Page 2)

holding Shift indicator plate. Remove Shift indicator plate.
Step 2. Remove the control cable clips. Remove the four
(4) shifter mounting bolts. Remove the shifter.
Step 3. Skip this step if you plan on using the B&M shift
cable (The B&M shift cable does not require the adapter).
Align the cable adapter holes with the U-shaped notch on
the B&M QuickSilver shifter and fasten it with a 1/4-20 x
3/4” bolt, 1/4” washer, and 1/4” nut supplied with the kit.
Place the B&M QuickSilver shifter in Neutral.
Step 4. Mount the indicator light socket to the B&M mount-
ing bracket with the 6-32 x .25” screw using a 5/64” hex
key. Wire the indicator light. Connect one wire from the
socket to a shifter mounting bolt. If your car had an indi-
cator light on the shifter, cut the old socket off and con-
nect the wire to the new light socket. Otherwise, run a
length of wire from the instrument panel light switch to the
new light socket. Tape all connections and splices to avoid
shorts. Install the supplied light bulb.
Step 5. Install the B&M mounting bracket to the floor.
Fasten it with four (4) 5/16-18 x 7/8” bolts, four (4) 5/16”
washers, and four (4) 5/16” lockwashers supplied in the
kit.
Step 6. Assemble the neutral safety and reverse light
switches to the bracket using two (2) 4-40 x 1-1/4” screws,
two (2) 4-40 lockwashers, and two (2) 4-40 nuts.
Step 7. Remove cross pin to allow screw to be installed in
location #1. First remove the e-clip with a small flat head
screwdriver ( be careful not to lose e-clip). Magnetic tool
along with screwdriver may be used. Slide pin out just
enough to allow screw to be inserted and tightened.
Step 8. Insert the cable through the B&M QuickSilver
shifter and install the appropriate hardware depending on
which cable is being used.
(B&M Cable: Attach the cable to the shifter with 1/4-20 x
1/2” Hex Bolt and 1/4” washer). Install the E-Clip that se-
cures the cable to the cable pin.
(Factory Cable: install the stock cable clip on the cable
fitting. Slip the cable eyelet over the cable pin on the shifter
and install the stock clip (See Figure #5)).
Step 9. Screw the shifter to the mounting bracket with a
3/16” hex key. (Note: Thread lock may be used on threads
for added security). Insert a 1/4-20 x 3/4” socket head
screw through location #1. Screw to bracket. Insert cross
pin back through shifter, and re-install the e-clip removed
in Step 7. Insert a 1/4-20 x 3/4” socket head screw along
with a 1/4” split lock washer to location #2. Screw to
bracket. Insert 1/4-20 x 3/4” socket head cap screw, 1/4”
washer, and 1/4” lockwasher to the remaining two mount-
ing holes (Location 3 and 4). Screw to bracket.
2
*FOR OEM
CABLE USE ONLY