Salter Brecknell MBS Series - Manual (Page 10)

10
Change Print Settings
You can select either Continuous Print or Print When Stable.
1. Remove all weight (except platter) and power the balance off.
2. Power the balance on.
3. During countdown (9999.99, 8888.88, 7777.77), press the Mode key. The
balance displays F1 A2t.
4. Press the Mode key. The balance displays F2 prt.
5. Press the Tare key. The balance displays either Pt-0 (continuous print)
or Pt-1 (bi-directional communication) Pt-1 is the default.
6. Press the Mode key until balance displays Pt-0.
7. Press the Tare key. The balance displays either PCon (print continuos) or
PStb (print when stable).
8. Press the Mode key to toggle between P2t6 and PCon.
9. Press the Tare key to accept the setting on the display.
10.Press the On/Off key when finished. The balance powers off and the
changes are saved.
11.Connect the balance to the printer or other device.
12.Power the balance on.
Care and Maintenance
Your precision balance does not require a lot of maintenance, however, there
are a few things you can do to keep your balance operating properly.
1. Keep the balance housing and weighing platform clean and free of
debris. Clean with a soft cloth dampened with detergent as necessary.
2. Unplug the AC adapter when not in use.
3. Remove batteries for long term storage. (See the section on battery
replacement.)
Battery replacement
You can expect approximately 15 hours of use when powering the balance
with batteries. Use only alkaline batteries of the correct size and pay close
attention to the markings (+ or -) inside the battery compartment.
Your balance should look similar to one of the two pictured below. Detailed
instructions are for models using screws to hold the lid in place only.