Salter Brecknell LPS-15 - Manual (Page 15)

LPS Series User Instructions 13
2. From normal weighing mode, press this key more than five seconds to access
Calibration mode.
ON/OFF/ZERO
1. Press this key to turn the scale on. The display will show the scale's capacity,
the scale will automatically zero if the weight is within 10% of the calibrated zero
point, and then 0 (kg/lb) will be displayed. This is normal weighing mode.
If the scale is not in zero-point range, the scale will display 0 ----- or
0 ____ and wait.
2. Press this key to zero any weight, up to 2% of full capacity on the scale.
3. Press and hold this key for five seconds to turn the scale off.
3.5 Setup Auto off Time, RS-232 and Hold Function Setting
Follow these steps to setup the auto off timer and the RS-232 settings:
1. With the scale in normal weighing mode, press the hold the UNITS key until. . .
A.oFF.x is shown. This shows that you are in the auto off time setting
mode. x can be equal to 1-9 minutes or 0, which means the feature is
disabled. Default value is 0.
2. To change the x value, press the UNITS key. . .
The x value will change and flash.
3. When the value you want is displayed, press the TARE key to accept the
value.
The value is stored and SP.X is displayed. This shows the unit is in the
RS-232 setting mode. X is defined below.
SP.0 No RS232 input or output
SP.1 Continuous data output. The scale will continuously communicate the
displayed weight including the unit of measure, a line feed and a carriage
return. Example below:
120.2 kg
120.3 kg
120.4 kg
120.4 kg
120.4 kg
SP.2 If the HOLD/PRINT key is active and pressed, the scale will transmit the
displayed weight, including the unit of measure, a line feed and a carriage
return once the weight becomes stable and locked on the display.
Example below:
120.4 kg