Salter Brecknell 7050 - Manual (Page 15)

Counting While
Using a Container
Entering Numeric Values
3. Place items to be counted on the scale. . .
Count and weight are displayed.
4. Repeat step three until you are done with all
identical identical identical identical identical items.
The display will then show “COUNT” in Area C,
weight in Area B, and show lb./pcwt and pcs
per lb. in Area D. Note that the weight shown in
Area B will indicate Gross weight, even though
a container weight might have been nulled
during the sample acceptance procedure. Net
weight will only be designated if a specific tare
value is entered.
By pressing the “UNITS” key, the metrological
display values will change to pounds and
ounces; piece weight will be expressed in
ounces and pieces per weight in pounds.
As pieces are added to the weight platter, the
count and weight will change accordingly. The
information in Area D will remain the same.
To perform a count while using a container,
place the container on the scale and press the
SAMPLE key. The scale automatically zeroes
and the scale is ready for bulk or dribble
sampling as described in the previous sections.
The 7050 will allow entry of numeric values for
manual weight (Man. Wt), piece weight (lb/
PCWT), pieces per pound (PC/lb), or ID number
(ID No.). Press one of these softkeys then enter
the numeric value to that function. The display
returns to normal operating mode with the value
active.
12