15 troubleshooting, 1 safety notices, 2 fault indications – CASO Germany MCDG 25 master User Manual

Page 64: Attention

Advertising
background image

caso MCDG 25 Master (black)

64

•

Smells can be removed from the oven by mixing a cup of water with the juice and the
skin of a lemon, pouring this into a deep microwave-proof bowl and allowing it to cook in
Microwave mode for five minutes. Then, dry off the oven thoroughly with a soft cloth.

•

After cleaning the interior space, leave the oven door open until the interior of the device
is completely dry.

Front of device and operating panel

•

Clean the front of the device and the operating panel with a soft, slightly damp cloth.

•

Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.

Please note

► Leave the oven door open to prevent the device from being re-started accidentally.

Exterior housing

•

Clean the exterior surfaces of the device with a damp cloth.

Turntable and rolling ring

•

The turntable must be removed and cleaned occasionally. Wash the turntable in a warm
soapy solution or in the dishwasher.

•

The rolling ring should be cleaned regularly to prevent excessive noise development or
rotational malfunctions.
The rolling ring can be washed in a mild soapy solution or in the dishwasher. Please
remember to put the rolling ring back again properly after cleaning it.

•

Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

Attention

► Only qualified electricians, who have been trained by the manufacturer, may carry out

any repairs on electrical equipment.

► Improperly performed repairs can cause considerable dangers for the user and

damages to the device.

15.2 Fault indications

In the event of a fault, an error code will appear in the display; it describes the cause of the
fault.

Advertising