CDI Torque TORQUE WRENCHES Dial Type - Manual (Page 12)

Page 9
Major Calibration
Turn the wrench over, with the dial facing down. On
the bottom of the case you will find a button plug.
Remove it.
Through the button plug hole you will see the
movement and push rod (The push rod is the black
part that is bent through the loop in the brass
movement). Check the push rod to assure it is
centered to the wrench and level (not pushed down
touching the plate or out of the movements loop).
The push rod needs to be reset in the movement:
♦
If the push rod is pushed off center
and to one side of the wrench or the
other.
♦
If the push rod is bent up so far as to be
coming out of the loop of the movement.
♦
If the push rod is bent down so far as to be
touching the plate.