CDI Torque TORQUE WRENCHES Dial Type - Manual (Page 13)

Page 10
Use the Dial Wrench Adjusting Tool (Part #600-2)
and gently move the push rod until it is centered to
the channel and in the movement loop and not
touching the plate Next, perform an accuracy
check.
NOTE
The Dial Wrench Adjusting Tool (Part # 600-2) allows
adjustments to be made in small, slight movements.
The adjustments to the push rod must be made in very
small increments, generally not to exceed .010 (.26mm).
Test the wrench on a torque tester after each
incremental adjustment.
CENTERING (Left or Right Adjustment)
Centering adjustment is required, if the wrench failed the accuracy check because it was
out in opposing directions (Example; +plus 4.5% in one direction and –4% in the
opposite direction) or near perfect in one direction and out in the opposite direction. To
center the push rod take the Dial Wrench Adjusting Tool (Part #602-2) and gently move
the push rod until it is moved slightly into the direction that the correction needs to be
made. An example of this would be a +plus 4.5% in one direction and –4% in the
opposite direction could be moved in the direction of the + plus reading. This would split
the tolerance between the two directions and center the wrench. Test the wrench to see if
the correction was enough to center the wrench readings so that both sides (CW & CCW)
are within specification requirements.