Climadiff VSV120 - Manual (Page 23)

23
Selecting the temperature
Functions of buttons
Set the RED button, enter this procedure of control mode: refrigerated storage temperature for red wines.
Set the WHITE button, enter this procedure of control mode: refrigerated storage temperature for white wines.
Light button: control the turn-on/ turn-off of the Wine cooler’s indicator light.
Press the SET button once, the preset temperature is shown for 10seconds, after that, it recovers to show the
chamber temperature.
Set the SET button (effective after a lasting 2 seconds press); enter selection procedure of manual temperature
adjustment. Flicker means it is setting the control temperature. The temperature control value cycles from 4°C to
18°C. Then press RED button (+) or the WHITE button (-). Each press changes the temperature by 1°C.
After all parameters are set, press the SET button. There is a beep to confirm and the flicker will stop. It returns to
show the current temperature. If there is no any operation during 10s, the machine confirms and stores the setup
automatically and returns to the current temperature.
Conversion of temperature units:
Press and hold the RED button for 2s, to change the temperature between Fahrenheit and Celsius.
Set the RED indicator light; under the red wines control condition, the RED indicator light is on.
Set the WHITE indicator light; under the white wines control condition, the WHITE indicator light is on.
Refrigeration indicator light: When the compressor is operating, the refrigeration indicator light is on. While the
compressor stops, the refrigeration indicator light is off. In the selection procedure of manual temperature
adjustment, the indicator lights of the RED and WHITE are off.
In general, when the compressor stops, the temperature in the chamber will rise gradually and the frost on the
evaporator will melt. The water will flow out of the chamber through the drainpipes to the drip pan. There is no
need to deforest specially.
When the lamp in the chamber is needed to be replaced, please draw off the power plug in advance. Loosen the
fixed bolts to remove the lamp cover. Loosen the bulb counterclockwise. Please contact the aftersales department
of you shop to purchase spare parts. Tighten it clockwise and fix the lamp cover with bolts.