Climadiff VSV120 User Manual

Page 24

Advertising
background image

24

5. EQUIPMENT


The anti-vibration system:


The refrigeration compressor is equipped with special dampers (silent-blocks) and the inner space is insulated
from the body by a thick layer of polyurethane foam. These characteristics prevent the transmission of vibration to
your wines.

The humidification system (only VSV120):


Since this appliance does not have a carbon filter, it is fitted with a tray that maintains the correct level of humidity.
If the humidity is too low, top up the level in the reservoir to three quarters of its capacity. Check the level from
time to time and add water if necessary. Ensure that the tray always contains water.
Designed by specialists for oenophiles, Vin sur Vin has taken into account the sensitivity of corks to too low a
level of ambient humidity. This is why the tray should be placed on the shelf below the fan situated in the bottom,
to provide minimum humidity. Be sure to check the water level, if you are storing wines over a long period and you
are not using the appliance solely for bringing wines to service temperature (with a quick rotation of bottles).

The anti-UV system:


Light accelerates the aging of wine. In our solid door cellars, your wines are naturally protected, on condition, of
course, that the door is not opened too often. Models with a glass door are UV treated, thus filtering out damaging
ultraviolet rays: your wines are therefore protected.

Defrosting:


Your appliance is equipped with an automatic defrost cycle. When a cooling cycle finishes, the appliance’s
refrigerated surfaces are defrosted automatically. The defrost water is channelled into a condensates evaporation
tray which is located in the back of the appliance near the compressor. The heat produced by the compressor
then evaporates the condensates collected in the tray.

Shelves

To prevent damage to the door seal, ensure that the door is fully open before pulling out the shelves to add

or remove bottles.

For easier access to the contents of the shelves, slide the shelf out approximately one third of the way. The

shelves are, however, fitted with a stop to prevent the bottles falling out.

To remove a shelf: pull it out until the cut-outs on the rack (right and left) are positioned under the side stops

(square black plastic part). Lift up and pull outwards.























Advertising
This manual is related to the following products: