DSS Networks 5161 - Manual (Page 25)

GigMAC PMC and PCI Board and Driver Users Manual
Using dmUtil dpm driver utility:
The “dpm driver utility” is used to capture detailed board levels statistics,
controller registers and to set loopback mode. Example usage of the “dmUtil” are
as follows:
dmUtil -s eth1 # get driver statistics for interface 1
dmUtil –p eth1
# get phy (transceiver) registers for interface 1
dmUtil –m eth1
# get MAC (PCI controller) registers for interface 10
dmUtil –t eth1
# get execution debug trace for interface1
(DEBUG_FLAGS trace option must be compiled in)
dmUtil –e eth1
# get eeprom configuration settings
dmUtil –ms eth1
# get mac MIB statistics
dmUtil –a eth1
# get mac address
dmUtil –w eth1 <0,1,2>
# write default eeprom configuration to controller
dmUtil –l eth1 <arg> # set controller in internal loopback mode
(driver must be compiled with –DNS_FRAME_TEST
in Makefile). Arg=1 for enable, 0 for disable.
DSS NETWORKS, INC. Version: 2.0 Page: 25