DSS Networks 5161 - Manual (Page 9)

GigMAC PMC and PCI Board and Driver Users Manual
Full-Duplex LED illuminates solid yellow
to indicate full duplex status
Transmit and Receive Activity Indicators
Transmit and Receive LEDs are on solid or blinking green
to indicate activity on the link (solid shows constant activity, blinking shows
intermittent activity)
Model 7160 with SC or LC connector
The front panel has onboard fiber optic connectors that supports the connection
of fiber optic cabling using 50 or 62.5 micron multimode fiber, SC or LC type
connectors with 4 LED indicators that provide the following as marked with
silkscreen nomenclature on front panels:
Two of the Yellow LEDs are used to indicate Signal Detect (SD) and Link Status
(LNK). The Signal Detect indicates the physical layer connection is established
while the LNK indicates that the auto negotiation has completed and the link is
established at the MAC and driver level.
The remaining two Green LEDs are used to indicate both transmit and receive
activity. All ports function in the same manner as shown in the Table below:
LED SUMMARY
Signal “SD” detect Indicator
On solid yellow when hardware detects valid signal from Fiber. Flashing or intermittent
yellow indicates poor signal quality and line errors.
Link “LNK” Indicator
On solid yellow to indicate auto-negotiation complete and MAC and driver level
link is up.
Transmit and Receive Activity Indicators
Transmit and Receive LEDs are solid or blinking green
to indicate activity on the link (solid shows constant activity, blinking shows
intermittent activity).
Model 6162 dual-port PCI with RJ-45 connector(s)
The front panel has two onboard RJ-45 connectors that supports the connection
of Category 5 cabling with 4 LED indicators per port that provide the following as
marked with silkscreen nomenclature on front panels:
DSS NETWORKS, INC. Version: 2.0 Page: 9