Dynojet Scooter Dyno SD-12 Manual - Manual (Page 19)

I N S T A L L A T I O N
Unpacking the Dyno
Version 3 Model SD12 Scooter Dynamometer Installation Guide
2-3
R EMOVING THE D RUM FROM THE C RATE
You will need to provide a 5/8-inch x 3-foot steel bar to lift the drum off the crate and
into position in your dyno room. Lifting the drum will require two people.
# RECORD
Be sure you record the dynamometer number on the inside cover of this
manual.
1 Remove the lag bolts and washers securing the drum to the crate base using a
9/16-inch socket, open or box end wrench.
2 Insert the 5/8-inch x 3-foot steel bar into the shaft hole.
3 Using two people, carefully lift the drum off the crate and move into position in
your dyno room.
Figure 2-1: Insert the Steel Bar and Lift the Drum off the Crate
axle shaft (2)
P/N 22100011
inductive primary pickup
clip
P/N DE100-110L
retaining ring, 1/2" (4)
P/N 32800000
cable tie, 4” (2)
P/N 197104130
screw, 1/4-20 x 5/8”, pan-
head, torx (2)
P/N 36561045
part description part description
SD018
steel bar
shaft hole