Dynojet Scooter Dyno SD-12 Manual User Manual
Page 21
Advertising
I N S T A L L A T I O N
Installation
Version 3
Model SD12 Scooter Dynamometer Installation Guide
2-5
2
Install the front support axle shaft.
3
Secure the shaft in place using two retaining rings.
Figure 2-3: Install the Axle Shaft and Retaining Rings
4
Slide the wheel clamp onto the front support.
5
Lift the spring plunger to slide the wheel clamp to a different position. Release
the spring plunger to lock the wheel clamp in the new position.
Note: The wheel clamp may already be installed.
Figure 2-4: Install the Wheel Clamp
SD004
axle shaft
axle shaft
retaining ring
SD007
wheel clamp
spring
plunger
Advertising